PingLive Sonar Setup Guide: Power & Connection Instructions

ACCUPHY PingLive & Wi-Fi Router/ BRICK Electrical Wiring Diagram

Connection Options

A) Wireless Connection via WiFi Router

Wi-Fi Router Compatibility
Device Model Year Released Port Type
iPad Pro 11-inch, 12.9-inch 2018 and later Wi-Fi
iPad Air 3rd Gen and later 2019 and later Wi-Fi
iPad 8th Gen and later 2020 and later Wi-Fi
iPad Mini 5th Gen and later 2019 and later Wi-Fi
iPhone iPhone 11 series and later 2019 and later Wi-Fi
  1. Connect the transducer to the WiFi module.
  2. Power the WiFi module by connecting it to your battery.
  3. Join the WiFi network on your iPhone/iPad:
  •   SSID: Accuphy_Router_One
  • Password: 12345678

Once connected, the system is ready to use.

B) Wired Connection via USB-C (Sonar I/F Unit)

For direct connection using a USB-C cable, ensure your device meets the compatibility requirements:

Device Model Year Released Port Type
iPad Pro 11-inch, 12.9-inch 2018 and later USB-C
iPad Air 4th Gen and later 2020 and later USB-C
iPad 10th Gen and later 2022 and later USB-C
iPad Mini 6th Gen 2021 and later USB-C
iPhone iPhone 15 series 2023 and later USB-C


Wired Setup Instructions

  1. Connect the USB-C cable to your iPhone/iPad.
  2. Turn off Wi-Fi on your device.
  3. Open Settings and navigate to [Ethernet].
  4. Select the Ethernet interface (10/100/1000 Mbps).
  5. Configure the IP settings manually:
  6. Tap [Configure IP] → Select [Manual]

Enter the following details:

      • IP Address: 192.168.10.88
      • Subnet Mask: 255.255.255.0

Tap [Save] to apply the settings.

Power Requirements

WiFi Router Input Range: 11–24V
Minimum Current Capacity: 5A

Following these steps ensures a stable and efficient setup for your sonar system. If you encounter any issues, refer to the FAQ or reach out for support. 

Article tags: